Project Reinforce Frame Parabolic Trough Evacuated Tube Heat Pipe Solar Collector U Pipe Solar Thermal Collector

Pressure copper U pipe U tube solar water thermal collector

U pipe solar collector

Working principle of CENTURY SUN U pipe solar collector.

The CENTURYSUN U pipe solar collector consists of 3 main components
1. ALL glass vacuum tube
2. Heat transfer system(solar cycle)
3. Frame

In each vacuum tube there is a U pipe with direct flow-through that is connected to the header pipe inside manifold. This U pipe is seamed in an aluminum heat transfer fin in the interior of vacuum tube that transmits the heat FROM the interior tube to the U pipe.
Solar radiation permeates the outer glass tube and is captured on the outside of inner glass tube by highly selective sputter layer. The captured solar radiation is transmitted to flush-contact aluminum shield and then copper pipe filled with heat transfer fluid. The 360°aluminum heat transfer fin assures the fastest energy transfer.

TECHNICAL SPECIFICATION

Different size collectors available on request

Image for reference only and may not be exactly same as real products.

PERFORMANCE

CSU collector has been tested to EN12975 and achieved a comparable high efficiency and with a very small heat loss coefficient. The COST/KWH value is smaller than most other collectors which mean you pay less for each KWH out put for our collector.

Above DATA is given to absorber area